P53 D
The Omni-block is made with an integrated swivel and locking side plate. Unlike traditional pulleys, the Omni is shorter in length and allows for rope change-overs without detaching the pulley.
RP5
The BOLT rig plate uses a quick-detatchable stainless steel rod, or ‘bolt’, that allows you to connect your gear directly to the five connection points without using carabiners. The result is a cleaner connection, and when pulleys are involved, more efficient use of space when lined up side by side than when using a traditional rig plate.
This is a 36" hollow tabless Lyra. It is finished with a glossy smooth gold powder coat. It is made of 1" hollow steel with a .120" wall thickness.
Being powder coated, there is a small section where it was hanging from. This is touched up with matching spray paint and is a good place to hang the lyra from a rope or polyester round sling (aka "Spanset")
Spreader bar for harness work. Steel with a black, lightly textured powder-coat finish. The two bottom rig points are 42 1/4" apart (center to center) and the center hole is 10 3/4" above them. WLL 200 pounds.
Spreader bar for harness work. Steel with a black, lightly textured powder-coat finish. The two bottom rig points are 33 3/8" apart (center to center) and the center hole is 9" above them. WLL 250 pounds.
Versatile spreader bar that can be used horizontally, or a vertical, extended spreader plate. This could also be used as a trapeze bar. It is steel with a black, lightly textured powder-coat finish. The rig holes on top and bottom are 24" apart (center to center)